At the moment it is not possible to connect to OPNSense. I was able to connect but after a restart I stopped getting assigned an IP Address via DHCP.
Background:I tried, to adjust the Interface settings for the PLC Network to an DHCP behavior. After restarting the PC (to force new DHCP leases on the PLC Network) I stopped getting an IP address via the LAN Interface.
I can still connect to the Proxmox layer but cannot identify any errors on the opnsense VM.
You killed the DHCP server
dhcpd: bad range, address 192.168.2.100 not in subnet 192.168.1.0 netmask 255.255.255.0
You managed to give the DHCP server an IP address outside of the actual ip range of the router. With this you crashed the DHCP server of the entire device (also for LAN). I needed to set manually my IP to a LAN address and then change the DHCP range for PLC from